Char: Difference between revisions
Jump to navigation
Jump to search
m (Remove extra whitespace) |
(Add navbox) |
||
| Line 3: | Line 3: | ||
Note that #char does not allow character 0 as a parameter, even though it is a valid extended ASCII character. Running <code>#char 0</code> will silently fail without changing the object's character. This restriction does not typically matter in practice because characters 32 and 255 are usually visually identical to character 0. | Note that #char does not allow character 0 as a parameter, even though it is a valid extended ASCII character. Running <code>#char 0</code> will silently fail without changing the object's character. This restriction does not typically matter in practice because characters 32 and 255 are usually visually identical to character 0. | ||
{{ZZT-OOP navbox}} | |||
Revision as of 04:02, 19 January 2021
#char is a ZZT-OOP command for changing an object's display character. It takes a single parameter, a decimal number from 1 to 255, representing the desired extended ASCII character.
Note that #char does not allow character 0 as a parameter, even though it is a valid extended ASCII character. Running #char 0 will silently fail without changing the object's character. This restriction does not typically matter in practice because characters 32 and 255 are usually visually identical to character 0.
| ZZT-OOP | |
|---|---|
| Prefixes |
|
| Messages | |
| Directions | |
| Flags | |
| Commands | |